Microchip (TC4426ACPA) MOSFET Driver Dual, Low Side Inverting

MOSFET Driver Dual, Low Side Inverting, 4.5V-18V supply, 1.5A peak out, 7 Ohm output, DIP-8 Product Overview The TC4426ACPA is a dual inverting high-speed power MOSFET Driver has highly latch-up resistant under any conditions within their power and voltage ratings. It is not subject to damage when up to 5V of noise spiking occurs on the ground pin. It can accept, without damage or logic upset, up to 500mA of reverse current being forced back into their outputs. All terminals are fully protected against electrostatic discharge (ESD) up to 4kV. The TC4426A MOSFET driver can easily charge/discharge 1000pF gate capacitances in under 30ns. This device provides low enough impedances in both the ON and OFF states to ensure the MOSFETs intended state will not be affected, even by large transients. Matched rise, fall and delay times 7R Typical low output impedance Latch-up protected - Will withstand 0.5A reverse current Input will withstand negative inputs up to 5V Pin-compatible with TC426/TC427/TC428 and TC4426/TC4427/TC4428 Applications Power Management Product Information No. of Channels: 2Channels Driver Configuration: Low Side Power Switch Type: MOSFET Supply Voltage Min: 4.5V Supply Voltage Max: 18V Driver Case Style: DIP Input Type: Inverting IC Case / Package: DIP No. of Pins: 8Pins IC Mounting: Through Hole Source Current: 1.5A Input Delay: 30ns Output Delay: 30ns Sink Current: 1.5A Operating Temperature Min: -40°C Operating Temperature Max: 125°C Qualification: AEC-Q100