Texas Instruments (SN65LVDS9638DGKR) Differential Line Driver, 2 Drivers

Product Overview The SN65LVDS9638DGKR is a differential Line Driver implements the electrical characteristics of low-voltage differential signaling (LVDS). This signaling technique lowers the output voltage levels of 5V differential standard levels (such as TIA/EIA-422B) to reduce the power, increase the switching speeds and allow operation with a 3.3V supply rail. Any of the four current-mode drivers will deliver a minimum differential output voltage magnitude of 247mV into a 100R load when enabled. The intended application of this device and signaling technique is both point-to-point and multidrop (one driver and multiple receivers) data transmission over controlled impedance media of approximately 100R. The transmission media may be printed-circuit board traces, backplanes or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling to the environment. Low-voltage TTL (LVTTL) logic input levels Driver at high-impedance when disabled or with VCC=0 Pin-compatible with AM26LS31, MC3487 and µA9638 Cold sparing for space and high-reliability applications requiring redundancy Low-voltage differential signaling with typical output voltage of 350mV and a 100R load Typical output voltage rise and fall time of 500ps (400Mbps) Typical propagation delay time of 1.7ns Operate from a single 3.3V supply Bus-terminal ESD protection exceeds 8kV Power dissipation 25mW at 200MHz/driver (typical) Green product and no Sb/Br Applications Wireless, Communications & Networking, Computers & Computer Peripherals Product Information IC Interface Type: - No. of Drivers: 2Drivers Product Range: - MSL: MSL 1 - Unlimited