- Out-of-Stock
DFRobot (DFR0457) Gravity: MOSFET Power Controller
R219.00
Tax included
In most Arduino projects, relays are the first choice to drive some large current device. It requires a certain amount of current to drive the internal coil to pick-up contact. But for some MCU, like Intel Edison, Intel Joule, lilypad, Raspberry Pi and other microcontrollers with a limited amount of current GPIO, it’s hard to drive one or more relays simultaneously.
Product Overview:
The MOSFET power controller is a module which can drive a large current device with limited current GPIO. It works as a MOSFET relay or MOSFET driver. When you give it a digital high-level signal (3.3~10V), MOSFET turns on, vice versa.
Compare to the relay module, MOSFET power controller is compatible with Arduino, Raspberry Pi, Lattepanda and other Microcontroller, supports 3.3~10V logic power control. The VIN port supports 5~36V; 0~20A power input, if the current is over 10A, we recommend an external heat sink. And MOSFET supports quick ON-OFF switch, the switching frequency arrives 1KHz. That is a good point for robot control.
The MOSFET power controller comes with a standard PH2.0-3P gravity interface. It makes the module compatible with the Arduino IO expansion shield. Plug and play, easy to use.
What's in the box
1 x MOSFET Power Controller
Comments (0)
No customer reviews for the moment.
16 other products in the same category:
In most Arduino projects, relays are the first choice to drive some large current device. It requires a certain amount of current to drive the internal coil to pick-up contact. But for some MCU, like Intel Edison, Intel Joule, lilypad, Raspberry Pi and other microcontrollers with a limited amount of current GPIO, it’s hard to drive one or more relays simultaneously.