DFRobot (SEN0250) Motion Sensor, I2C BMI160 6-Axis Inertial, DFRduino

Product Information Silicon Manufacturer: 0 Accessory Type: I2C BMI160 6-Axis Inertial Motion Sensor Silicon Family Name: - Core Architecture: - Core Sub-Architecture: - Silicon Core Number: 0 Kit Contents: 0 For Use With: 0 Product Range: Gravity Series Product Overview SEN0250 is a Gravity I2C BMI160 6-axis inertial motion sensor module based on Bosch BMI160 6-axis MEMS sensor which integrates 16bit 3-axis accelerometer with ultra-low-power 3-axis gyroscope. Bosch BMI160 is designed for smartphones, tablets, wearable devices. It has built-in intelligent step-counting algorithms that can be read directly through registers. Built-in 3-axis acceleration and 3-axis gyroscope can detect running, fitness and other motion. Built-in LDO power management chip, supports 3.2 to 6V wide voltage power supply and also has I2C level conversion circuit, compatible with Arduino 3.3V and 5V micro controller. Step count, acceleration detection Inclination measurement, display toggle horizontal / vertical mode Current consumption of less than 1mA Gravity-I2C interface, ±2g/±4g/±8g/±16g acceleration range Gyroscopes range of ±125°/s, ±250°/s, ±500°/s, ±1000°/s, ±2000°/s ±40mg acceleration zero-g offset, ±10°/s gyroscopes zero-g offset 25/32Hz to 1600Hz programmable frequency 6D detection and location, 16bit data output in-built 1024byte FIFO Two independent programmable interrupt generators Working temperature range from -40°C to +85°, dimension is 22mm x 27mm/0.87inch x 1.06inch