Tt Electronics (OPB625) Transmissive Photo Interrupter, 10K Pullup

Transmissive Photo Interrupter, 10K Pullup, Through Hole, 4.826 mm, 1.52 mm, 10 mA, 3 V Product Overview The OPB625 is a Photologic® Slotted Optical Switch with 10K pull-up (buffered or inverted) output. This printed circuit board mounting switch consists of an 890nm, infrared light emitting diode (LED) and a monolithic integrated circuit that incorporates a photodiode, a linear amplifier and a Schmitt trigger on a single silicon chip. Device is also TTI/LSTTL compatible and can drive up to 10 TTL loads. Suitable for mechanical switch replacement, speed indication (tachometer), mechanical limit indication and edge sensing. Non-contact switching Enhanced signal to noise ratio 240mW Power dissipation -40 to 100°C Operating temperature range Applications Sensing & Instrumentation, Industrial Product Information Sensor Output: 10K Pullup Sensor Mounting: Through Hole Gap Width: 4.826mm Aperture Width: 1.52mm Forward Current If: 10mA Reverse Voltage Vr: 3V Forward Voltage: 1.6V Product Range: OPB625 Series