DFRobot (SEN0098) Sensor Breakout Board, Arduino IO Expansion Shield

Product Information: Accessory Type: Sensor Breakout Board For Use With: Arduino IO Expansion Shield Product Range: Gravity Series Product Overview: Analogue 50A current sensor (AC/DC) breakout board for the fully integrated Hall effect based linear ACS758 current sensor. The sensor gives precise current measurement for both AC and DC signals. The thickness of the copper conductor allows survival of the device at high overcurrent conditions. This current sensor enables you to monitor currents in your project every second for energy saving or circuit protecting purposes. Arduino interface compatible 120kHz typical bandwidth Output voltage proportional to AC or DC currents Factory-trimmed for accuracy Extremely stable output offset voltage Nearly zero magnetic hysteresis Total output error improvement through gain and offset trim over temperature Monolithic hall IC for high reliability Ultra-low power loss: 100µR internal conductor resistance Operating Voltage: 3.3-5V (analogue) Peak Measuring Voltage: 3000V AC, 500V DC Current Measuring Range: -50 to +50A Sensitivity: 40mV/A Operating Temperature: -40 to 150°C Board size: 34x34mm Applications: Embedded Design & Development, Electronics Design, IoT (Internet of Things) Contents: Sensor board, Analogue sensor cable